Menu

Category: Wireless

Getting Started with Duinopeak SIM808 GPRS/GSM+GPS Shield-GPS Positioning

0 Comments

Prepare Hardware Required hardware as below: Duinopeak SIM808 GPRS/GSM+GPS+Bluetooth all in one Shield Active GPS Antenna An Peakduino UNO or Arduino UNO USB cable for your Peakduino UNO or Arduino UNO 12V/9V/1.5A Power supply

Getting Started with Duinopeak SIM808 GPRS/GSM+GPS Shield-Call up

0 Comments

Make sure your got everyting ready, if not see Hookup Guide and AT Commands Simple Test, let’s get started. First of all we need hook up the hardware as below.

Getting Started with Duinopeak SIM808 GPRS/GSM+GPS Shield-Hookup and Simple Test

0 Comments

As we know, this Duinopeak SIM808 Shield design for use as an extension board of Peakduino/Arduino UNO, and it requires a external power supply. Prepare Hardware Required hardware as below: Duinopeak SIM808

Getting Started with Duinopeak SIM808 GPRS/GSM+GPS Shield-Overview

0 Comments

Introduction SIM808 shield is a GSM and GPS plus Bluetooth three-in-one function shield for Peakduino/Arduino. It is based on the latest GSM/GPS/Bluetooth(optional) module SIM808 from SIMCOM, supports GSM/GPRS Quad-Band network and

Getting started with Duinopeak GPS Logger Shield-µSD Card GPS Logging for NEO-M8N

0 Comments

Now that we have good GPS data, the final step is to start logging it to a µSD card. Like the last example, this sketch uses TinyGPSplus-for-Neo-M8N, it also uses Arduino’s

Getting started with Duinopeak GPS Logger Shield-µSD Card GPS Logging for NEO-6M

0 Comments

Now that we have good GPS data, the final step is to start logging it to a µSD card. Like the last example, this sketch uses TinyGPS++, it also uses Arduino’s

Getting started with Duinopeak GPS Logger Shield-Serial Streaming for NEO-M8N

0 Comments

A GPS-parsing Arduino libraries specifically for M8N are TinyGPSplus-for-Neo-M8N. These libraries simplify the task of parsing the excessive NMEA strings, leaving us with just the few bits of data we care about.

Getting started with Duinopeak GPS Logger Shield-TinyGPS Serial Streaming for NEO-6M

0 Comments

A couple of our favorite GPS-parsing Arduino libraries are TinyGPS and TinyGPS++. These libraries simplify the task of parsing the excessive NMEA strings, leaving us with just the few bits of data we

Getting Started with BLE Shield-Connect with Android phone

0 Comments

First of all, we need let the device works on Slave mode, so the Android phone master device can find the BLE shield. Prepare the hardware. Stack the BLE shield

Skip to toolbar